Repairing a driveway

Step 1: Enter Your Zip Code. What are some tips for repaving a driveway? Should I repair or replace my driveway? How can I repair low spots in my cement driveway?

Put the mix (or compound) in a large bucket and add water as directed on the label.

A mixer paddle attached to a heavy. Pour the wet mix into the cracks and use the pointed end. DRIVEWAY REPAIR SOLUTIONS Patch or fill small cracks.

Cracks or holes less than ¼” wide generally don’t pose a structural threat and can be filled. Large cracks or holes greater than ¼”, spalling. Clean the cracks, using a strong spray from a garden hose. Concrete engraving to disguise.

Remove the tree and fix or replace the affected section.

The fixes are always temporary because water will seep in between the old and new material and start to open up the hole again. Start by using a pressure washer to remove any mol mildew, and dirt. After wetting down the slab, a special masonry cleaning solution is added to the reservoir on the pressure washer and sprayed on the surface.

By Stonemason Landscapes, My other job. Repairing a gravel driveway starts with getting the driveway surface as close to universally smooth and even as you can. Masonry Tuckpointing Contractors.

US CA) or land plane with scarifiers ( US CA) to break up the overall surface to a universal depth. If you have erosion, potholes, etc. Tackling a damaged driveway may seem like an overwhelming task, but the truth is that. Before you can actually set about the process of making repairs.

Rake the gravel over the driveway to even the grade. Pour additional gravel into potholes, since you may not be able to recover all of the gravel you lost. You can either try and cut the. Sweep any loose dirt and chunks of concrete out of the pothole with a broom. Spray the pothole with a garden.

Put on a mask, waterproof gloves and waterproof boots to protect you while working with concrete. Asphalt driveways have always been popular because they are much less expensive than concrete and easily repaired.

One needs only to scratch out the cracks, clean and scour the surface to aid in bonding, and then pour a thin layer of asphalt on the surface. Compress and leave to cure for a few days and the driveway looks good as new. Sand can be used to repair cracks in a driveway. Cleaning is the next step, and driveways should be swept to remove loose dust, dirt, and other debris.

Cracks can be cleared of any remaining dust by using a hose or air compressor. Serving Upstate NY area. Lowest prices around. Specializing in spalling and asphalt repairs.

Call today for a free estimate.