How to repair a psp screen

You can buy a new screen and a great repair manual for bucks total. Try bring it to the shop you bought and ask, or do it yourself. They will also teach you to. How do you remove a PSP screen?

How to replace PSP 300X LCD screen?

The technique used is: start with a high grade. It is highly recommende before starting to san that you remove the outer screen by taking out the set of tiny. Start with a grade of sandpaper that makes scratches of. This was the very first time that I did it. I hope this video helps you out if you decide to replace your.

Check that everything fits, by aligning your faceplate with your psp, adjust if it does not fit. You do NOT want any dust to be trapped in your PSP Screw the screws into place. PSP 300x LCD Screen Replacement Step Battery.

Place the PSP face down and locate the battery cover on the left side of the device. Peel back the warranty sticker that is behind the battery with a spudger or your fingernail. Unscrew all four screws. The actual screen was OK but the PSP 100x has a face plate which has a clear section that lays right over the screen , in my case this is what was scratched.

I purchased a new 100x faceplate from Amazon, the fit was decent as was the quality and durability of the plate itself but some of the words on the face plate were slanted and sloppy. Comprehensive set of repair guides for handheld consoles manufactured by Sony, from the original PSP to the ultra-portable PSP Go. Sony Handheld Console troubleshooting, repair , and service manuals. The thin Ribbon Cable opens from the opposite side in which the Ribbon Cable enters.

Open up the latch towards the Ribbon Cable. The latch will pull up and release the ribbon cable. Put your tool behind the black part, then pry up the black piece of plastic. The wide Ribbon Cable opens from the same side in which the Ribbon Cable attatches, and opens away from the cable.

To understand how to fix a PSP screen , separate the faceplate from the PSP. Get the butter knife. Carefully wedge the screen borders. This will allow you to pry off the LCD screen.

Find the one inch film-like strip hooking up the PSP to the LCD screen. Look for the tab and pull it up. I will reveal to you two tested methods for the repair of PSP screen.

This is a very efficient scratch removing solution particularly meant for Sony PSP console. Pull the LCD screen forwar d. Release the LCD screen from the motherboard to do this, release the lock jaw connectors. Lift the connectors using a safe pry tool.

The LCD Screen is held by the LCD Frame with similar clips. Slide a thin tool between the clip and the screen and gently pry them apart while beginning to lift the screen. Gently pry the front bezel away from the casing using a PSP opening tool. Start on the right hand side of the PSP bezel, and carefully work the tool around the side.

If you want to clean the control buttons or D-pa you can easily pop them out once the faceplate is off and wipe them clean. These usually clean the internal settings of the PSP for example the software program as well as the internal hardware removing all the corrupt files that may cause the blue screen of death to appear.